AS-CF126L ceiling fan remote control kit consists of two pieces as shown in Fig. 1

      l An infrared remote control unit with a wall mount bracket; and

      l A U shape receiver that can receive control commands from the remote control unit.

                 This receiver uses existing wiring and can easily fit into the canopy of the ceiling fans.

  Fig. 2 is a large view of the LCD display ofAS-CF126L remote control unit. The displayed

  parameters include timer fan speed fan status and light status.

  AS-CF126L remote control unit is battery driven and there is no wiring requirement. The receiver

  has its all connection wires clearly labelled as shown in Fig. 3.

                    ACL:           Connected to the hot wire of power supply

                    ACN:          Connected to the neutral wire of power supply

                    Light:          Connected to the lights

                    Motor:         Connected to the fan

                    COM:         Connected to the neutral wire of the fan and/or lights

  Warning: Please make sure power is turned off before starting installation!

  Once properly wired the AS-CF126L receiver can be installed into the canopy of the ceiling fan

  as shown in Fig. 4.

  Note:   The two infrared detectors should be arranged to face two orthogonal directions.

  Fig. 5 shows the front and the back of the remote control unit. Before operating ceiling fan and

  lights please complete the following two procedures:

           a.    The remote control unit uses one 23A 12V battery. Please open the sliding cover and

                  install the battery.

           b.    Turn on the power supply to the ceiling fan and lights. If there is another switch to

                  control the fan speed and the lights please set the switch to the highest fan speed and

                  turn on the lights.

  Now it is ready to control the ceiling fan and lights using the remote control unit.

  1.     Turn on fan:    The remote control unit has three buttons LOW MID and HI. Pressing each

  of these three buttons will turn on the fan and set the fan to low speed medium speed and high

  speed respectively. The fan indicator on the LCD display will be on the fan speed indicator will

  show different height corresponding to the fan speed and the fan speed display shows the current

  fan speed: 0 (off) 1 (low speed) 2 (medium speed) and 3 (high speed).

  2.     Turn off fan:    Pressing the FAN/Off button will turn off the fan.

  3.     Turn on or turn off light:    Pressing the LIGHT On/Off button will turn on or turn off the

  lights. When the light is on the displayed light indicator is on.

  4.     Set up timer:    When the fan is on pressing the TIMER button will select four timer hours 1

  hour 2 hours 4 hours and 8 hours respectively. Other customized timer hours can be made

  available at factory.

  When the timer is activated the timer indicator is on and the timer starts countdown. The fan will

  be turned off once the countdown timer runs out time.